A Favorite Made Even Better Performs like the more expensive, top-tier shafts Unique stiffness distributions for each flex maximizes distance and control For golfers with medium to slightly quicker tempos/transitions and swing speeds up to 105 mph. (Continued Below)
|Model/SKU Number||Flex||Recommended Swing Speed (Driver mph)||Trajectory||Weight||Length||Butt Diameter||Tip Diameter||Parallel Tip Section||Torque|
The value-priced, high-performance RT6* Wood Golf Shafts are among the most consistent and stable wood shafts in the industry regardless of price. We've incorporated an ultra high-strength material into the shafts that fine-tunes their stiffens distributions, especially in the lower sections without any gain in weight. These design upgrades allow for a more consistent and optimal ball flight with just the right amount of spin for each flex - not just a weaker upper section for each flex.
Go Long, Stay Strong & in the Middle.
The new designs of the RT 6* shaft line have unique progressions and distributions of stiffness for each flex. The A-flex sports a soft-medium profile while the R-flex has a medium-stiff profile along their entire lengths. The S-flex features a medium-stiff profile along its full length but with a lower portion that is much stiffer.
To verify that every shaft we make performs as designed, we conduct 100% frequency inspections at 0 and 90 degrees of both the butt and lower sections of the woods-—an industry first. Other companies only frequency test a single point on the butt.
If you have a slow to medium swing speed in the 75-95 mph range with a slower to medium transition/tempo, using the A- or R-flexes expect a medium to medium-high launch without excess spin. This combination will help you hit longer, more controlled shots.
If you attack the ball aggressively and your swing speed is 95-105 mph, when using the S-flex expect a slightly lower launch without excessive spin. This will allow you to maximize distance and optimize control.
Standard Trim Instructions:
- 0 in. for a driver, 0.5 in. for a 3-wood, etc.; max 1.5 in.
Experienced Club Makers:
- A maximum for any head is 2 in., providing the bore depth is sufficient.
Note: Trimming instructions are not set in stone (as many companies will maintain). Rather they are a basic guide for assembly.
Experimentation is definitely allowed and even encouraged once one has experience with the performance of any Xcaliber shaft.